I cannot say enough about how great these look. My old units were cloudy and my lights were more for showing other drivers where I was rather than helping me to see the road. So when one of the old units was broken, it was the perfect time to replace them with something better.The installation was reasonably easy for someone who had never done this type of work before. You do have to remove much of the front bumper cover and open up both of the plastic areas inside the fenders. The front grill area must also be opened up or removed to access the two screws in there. Those plastic areas inside the fenders cover one screw on each side as well. I destroyed a bunch of the plastic clips to access these areas, but they are available for replacement.Be aware that to access the turn signal lightbulb, you will be removing those plastic areas inside the fenders. This was true of the original units as well and isn't a design flaw with the product. Just something to be aware of before you start. I made the choice to replace both of those turn signal bulbs while I had the fender opened up. This assembly comes with a nice hole into which you can insert your existing bulb and base though I was unable to use the rubber washer they provided.There is also a metal frame piece that butts up directly behind the low beam bulb. I installed both units and then tried to remove the low beam bulb on driver's side to see what a replacement bulb would be. I immediately discovered that I was unable to remove the rubber boot from the back of the bulb area. With a bit of work, I could push it mostly to one side, but still wasn't able to get the bulb out. The power steering unit sits directly behind that area as well, which makes it difficult to get your hand in there.The pros still far outweight these couple of minor issues for me. The new assemblies look great and I can see the road again. I would happily purchase these again and would recommend them to anyone looking to replace the old units.